 |
||||||||
|
Dated Posted : 19/07/2004 |
||||||||
|
Okay, me A/C lights have stopped working...somehow, not sure why. Its been like that for ages, till i finally decided to pull a finger and do something about it. Here are some pix i have taken away the way. |
 |
|||||||
| So, first you need to pull the dash out. about six screws. Pull that out, unplug the all cables. |  |
|||||||
|
Once out, it was off to the workstation (Spot the lotto ticket ). |
 |
|||||||
| Now on this pic, i have dotted a circle around where a small light adaptor thingy will be going. | 
|
|||||||
| Small light adaptor/holder is shown in this pic. | 
|
|||||||
| Now, i had to pull it apart, cuz i wasnt going to use the light adaptor, it was too much work. So i pulled it apart and soldered it straight on the PCB. |
|
|||||||
| Shot of the other part. Now in this pic, is new light blub. Its next to the long nose pilers. Its a little piece of white plastic. Cost about $5 bucks each at your local electronics shop. |
|
|||||||
|
Now its time to slap it back on. Make sure to put all the connectors back on. |
|
|||||||
|
Night Time Check = PASS! You beauty!
A job well done. Nice and easy. If any questions email me. End of Article Ash. |
|
|||||||
|
|
|
|||||||
